Microconic Regular Collets
Microconic Collets enable your shop to convert all of your facilities turning machines spindles to ONE, universally sized, collet for your small diameter workholding. Currently they are available in a UM10 size but a new UM6 collet system is planned for launch with our TF16 Cartridge system in 2017.
From 15 minutes to 60 seconds for accurate set-up & changeover! Converting a 16C to a 5C collet in a shop to gain additional small diameter clamping range usually results in a tolerance accumulation and generally takes over 15 minutes to change the collets. By using our Microconic collets, once the cartridge is in place, you can easily install our collets and set the clamping pressure as you desire right at the spindle nose in about 60 seconds. |
10mm Microconic Collets
|